AES67 Network Setup

To configure the AES67 download latest generation Audio Grid Controller Software. Your PC needs to be connected to the AES67 network and have its addressing set in the same IP range.

AudioGridController

AES67 Network Address Setup

Start the software and go to the “Device Config” tab

  1. Select the device to be configured
  2. Enter “IP Address” and “Subnet Mask”
  3. Hit “Apply”

AES67 Stream Address Setup

Caution

The AES67 stream of each device needs to be configured to be received by the Dante/AES67 devices

Start the software and go to the “Device Config” tab

  1. Select the device to be configured
  2. Select “Create / Delete” in the “Multicst flow” selection

Picture Picture

  1. In the Multicast flow config, click on “AG” first and then on “AES67”. Next, select the “Manual IP and Port” option.
  2. You can set your desired multicast IP. Typically in combination with Dante Audio products, the multicast IP starts with “239.69.”, port 5004.
  3. Select the channels that should be multicast.
  4. Click on “Create”.

Picture Picture